Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
- 12. Body
   12.1. Maintenance and repair
   12.2. Vinyl furnish
   12.3. Upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repair of openings from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. Windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. Cover of a back compartment
   12.16. Bumpers
   12.17. Forward facing lattice
   12.18. External mirrors
   12.19. Forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. Hatch
   12.23. Holder of a spare wheel
   + 12.24. Salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. Ceiling upholstery
   12.28. Switch of the door lock
   + 12.29. Door glass, window regulator and window regulator electric motor
   12.30. Windscreen
   12.31. Back glass
   12.32. Vnutrisalonnoye rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. Electric equipment
+ 14. Electroschemes






12.25. Internal panels of doors

GENERAL INFORMATION

Internal panel of a door

1. Figured spring ring
2. Window regulator handle
3. Slip
4. Internal handle
5. Window regulator switch
8. Panel
9. Door handle
10. Pocket

Removal and installation

PERFORMANCE ORDER
1. Remove triangular facing of a lateral mirror.
2. Remove caps, unscrew screws and remove an armrest and the handle.
3. Unscrew the screw, having removed a cap, and remove an internal overlay of the door handle.
4. Wring out a figured spring ring and remove the window regulator handle. It is recommended to designate position of the handle by a sticky tape.
5. On a part of cars turn out the handle of a clamp of the door lock (the square button of a clamp acts in film after a raising of the panel of a door).
6. Unscrew fastening screws on a panel contour, with the thin flat bifurcate tool remove latches (from 6 to 12 pieces (1 – a core, 2 – facing)).
7. Raise the panel, having deduced from gearing with the bottom uvulas, disconnect wires (if are available) and remove the panel. Do not damage the water filter in a door framework, otherwise water will get to salon.
8. At installation attach wires and combine the panel with the top edge of a door and besiege on uvulas in easy blows of a palm.
9. Further assembly is carried out upside-down.
10. Establish latches (1 – a sealant, 2 – a core, 3 – facing).
11. The handle of a window regulator establish on the pasted tape, having combined a shlitsa of the handle and the roller.
12. In sharp blow of a palm on the center of the roller drive the handle against the stop.