Mitsubisi Padzhero + 1.1. Dashboard and control units + 2. Maintenance + 3. Engines + 4. Cooling system + 5. Greasing system + 6. Power supply system + 7. Release system - 8. Fuel system - 8.1. Carburetor engines 8.1.1. Mechanical fuel pump - 8.1.2. Carburetor 8.1.2.1. Removal and carburetor installation 8.1.2.2. Dismantling and carburetor assembly + 8.2. Engines with fuel injection + 8.3. Diesel engines + 9. Running gear + 10. Suspension bracket and steering + 11. Brake system + 12. Body + 13. Electric equipment + 14. Electroschemes
|
The details shown at removal of the poplavkovy chamber of the Feedback-carburetor (the engine of 2,6 l)
1. Returnable spring butterfly valve 2. Dempferny spring 3, 5. Arm 4. Pneumoshock-absorber 6, 8. Hose
|
7. Dempfiruyushchy valve 9. Screw 10. Cover of the poplavkovy chamber 11. Laying 12. Lower part of the carburetor |
Removal and installation
CARS WITH THE NON-FEEDBACK-KARBYURATOROM
PERFORMANCE ORDER |
1. Disconnect the battery from weight, remove the air filter. |
2. Designate and disconnect from the carburetor a fuel hose and all vacuum hoses. Disconnect a butterfly valve cable. |
3. Unscrew bolts and remove the carburetor. Merge gasoline from the poplavkovy chamber. |
4. Installation is carried out upside-down. |
5. Check a condition of the plane of a flange of the carburetor and replace laying. |
6. Adjust a cable of a drive of a zaslonka – by pressing a pedal the zaslonka should occupy vertical situation. |
7. Before start-up of the engine check correctness of accession of all wires and hoses, fastening of devices of the carburetor. |
|
Prevention
It is forbidden to fill in for simplification of start-up gasoline in diffuzor of chambers of the carburetor.
CARS WITH FEEDBACK-KARBYURATOROM (4-CYLINDER ENGINES)
PERFORMANCE ORDER |
1. Disconnect the battery from weight, remove the air filter, having disconnected hoses and an air line. |
2. Merge liquid. |
3. Disconnect a butterfly valve cable. |
4. Designate and disconnect all vacuum hoses and hoses of cooling liquid. |
5. Designate and disconnect from the carburetor conducting sockets, holding the socket case. |
6. Disconnect fuel hoses. |
7. Unscrew bolts and remove the carburetor, merge from it gasoline. |
8. Remove laying, if necessary remove a thermoelement. |
9. Installation is carried out upside-down. |
10. Check a condition of the demountable planes of fastening of the carburetor and replace laying. |
11. Tighten bolts with the moment of 18 N of m. |
12. Adjust a cable of a drive of a zaslonka. |
13. Before start-up of the engine check correctness of accession of all wires and hoses, fastening of external devices of the carburetor. |
14. After warming up of the engine adjust idling turns. |
|
|
|