Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
- 6. Power supply system
   6.1. Introduction
   6.2. Air removal from a power supply system
   6.3. Water removal from the fuel filter
   6.4. Replacement of a filtering element of the fuel filter
   6.5. Removal and TNVD installation
   6.6. Idling adjustment
   6.7. Check of system of prestarting heating of the engine 4D56Т
   6.8. Control unit check by prestarting heating
   6.9. Check of the relay of inclusion of starting candles
   6.10. Removal and turbokompressor installation
   6.11. Check of pressure of pressurization
   6.12. Vozdukho-vozdushny cooler
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






6.11. Check of pressure of pressurization

GENERAL INFORMATION

Prevention

Check of pressure of pressurization should be made by two checking in such place where car dispersal is possible at the pedal of an accelerator pressed to the full. Pressure on a manometer should be read out checking, sitting on the right forward seat.


PERFORMANCE ORDER
1. Disconnect a hose from the proof-reader of supply of fuel on pressure of pressurization of TNVD, through a tee attach a control manometer and transfer it to car salon.

2. Disperse the car on the II transfer at the pedal of an accelerator pressed to the full and at frequency of rotation of a cranked shaft about 3000 rpm check on a manometer pressure of pressurization which should correspond to the values given in subsection 6.1.
3. If the received value less demanded, malfunction of a regulator of pressurization, a leakage of air pipes and hoses of a turbokompressor and violation of work of a turbokompressor can be the reasons of it.
4. If the received value more normal, the following malfunctions in system of regulation of pressurization are possible:

  – detachment or damage of a vacuum hose of a pneumodrive of a regulator of pressurization;
  – malfunction of a regulator of pressurization;
  – malfunction of the valve of pressure of pressurization.