Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
- 2. Maintenance
   2.1. Periodicity of service
   2.2. Refueling capacities
   2.3. Filter replacement
   2.4. Fuel filter
   2.5. Zolotnik of ventilation of a case (petrol engines)
   2.6. Care of the battery
   2.7. Drive belts
   2.8. Hoses of system of cooling
   2.9. Covers of CV JOINTS
   2.10. Conditioner service
   2.11. Screen wiper brushes
   2.12. Wheels and tires
   2.13. Recommended fuel, liquids and lubricants
   + 2.14. Engine
   + 2.15. Cooling liquid
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






2.12. Wheels and tires

GENERAL INFORMATION

Check of depth of a protector


Check of wear and damages of tires


Care of tires is reduced to check of depth of a protector, pressure in tires (it is checked on cold tires), to identification of traces of abnormal wear and damages by which it is possible to determine a condition of details of a forward suspension bracket and a steering.

Regularly delete the stones which have got stuck in a protector or sharp subjects. Periodically remove wheels and clear external and internal surfaces of a disk of dirt.

If there are doubts concerning consequences of any found damages, address for consultation in a shinoremontny workshop. Rearrange wheels with a certain periodicity. At installation of the new tire on a disk consider the following.

The width of a protector of the tire should differ from distance between internal boards of the tire no more than on 25 mm. On radial tires the width between internal boards should be no more than 80 % from width of the tire.

The tire height in the established condition essentially influences accuracy of indications of a speedometer, on dynamics of dispersal and a car road clearance. Necessary amendments are specified by the manufacturer of tires. In the spare part speedometer reducers with the corrected transfer number are delivered.

At installation of new tires it should not be observed an abnormal inclination of a body when driving on the bumpy road or at turns.

Shift of wheels

Scheme of shift of wheels

Wheels are rearranged for the purpose of increase of uniformity of wear of tires through 12000 km.

At removal of winter shipovanny tires designate the provision of a removed wheel and the direction of thorns. Shift of the wheels which tires are calculated on different loadings is not allowed and are established on forward and back axes separately.

The manufacturer recommends to establish radial tires in a uniform set (5 wheels). It is allowed to establish in extreme cases radial tires of an identical design on a back axis.