Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
+ 11. Brake system
- 12. Body
   12.1. Maintenance and repair
   12.2. Vinyl furnish
   12.3. Upholstery and rugs
   12.4. Repair of small scratches
   12.5. Repair of dents
   12.6. Repair of openings from a rust or dents
   12.7. Filling and painting
   12.8. Repair of considerable damages
   12.9. Loops and locks
   12.10. Windscreen and motionless glasses
   12.11. Removal and installation of doors
   12.12. Door adjustment
   12.13. Removal and cowl installation
   12.14. Cowl adjustment
   12.15. Cover of a back compartment
   12.16. Bumpers
   12.17. Forward facing lattice
   12.18. External mirrors
   12.19. Forward aerial
   12.20. Removal and installation covered
   12.21. Body support (fastening to the chassis)
   12.22. Hatch
   12.23. Holder of a spare wheel
   + 12.24. Salon equipment
   12.25. Internal panels of doors
   12.26. Facing panels of salon
   12.27. Ceiling upholstery
   12.28. Switch of the door lock
   + 12.29. Door glass, window regulator and window regulator electric motor
   12.30. Windscreen
   12.31. Back glass
   12.32. Vnutrisalonnoye rear-view mirror
   + 12.33. Seats
   12.34. Seat belts
+ 13. Electric equipment
+ 14. Electroschemes






12.22. Hatch

GENERAL INFORMATION

Hatch (1992-98)
1. Switch
2. Electric drive
3. Control unit
4. Back arm
5. Hatch
6. Forward arm
7, 8. Drainage hoses

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the panel of the switch and disconnect conducting.
3. Remove a ceiling upholstery (see subsection 12.27).
4. Close the hatch and remove the hatch electric motor (if it is impossible to close the hatch, designate the provision of a cover and directing).
5. Designate the provision of a reducer of a drive on an arm.
6. Remove the control unit.
7. Remove a back arm, get the hatch in collecting and remove a forward arm.
8. Drainage hoses remove only if necessary.
9. For removal of a hose attach to it a cord, having wound with a tape and stretch a hose in salon (1 – a sealant, 2 – a tape, 3 – a cord, 4, 5 – a hose).
10. Installation is carried out upside-down.
11. A hose stretch, having attached to it a cord a sticky tape (at the left – a forward drainage hose, on the right – back; 1–a sealant, 2 – a hose).
12. At replacement of the electric motor slightly open the hatch on 20 cm and establish an opening of a gear wheel of a reducer so that it was between teeths of a gear wheel of the electric motor (1 – a reducer gear wheel, 2 – a leading gear wheel, 3 – an opening).
13. At installation of the removed drive combine the put labels.