Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.5. Removal and pedal installation

GENERAL INFORMATION

Pedal of a brake (1983-86)

1. Plug
2. Arm
3. Switch
4. Draft
5. Spring
6. Pedal (MKPP)
7. Pedal (AKPP)

Pedal of a brake (1987-98)

1. Switch
2. Spring
3, 6. Шплинт
4, 7. Washer
5. Axis
8. Cable
10. Pedal
11. Plug
12. Rasporny plug
M/t – for MKPP
And/t – for AKPP
A.Smazat

PERFORMANCE ORDER
1. Disconnect the battery from weight, remove the switch of a signal of braking, disconnect a pedal spring.
2. Rasshplintuyte also remove a pedal axis.
3. Rasshplintuyte also disconnect a cable from transmission (on and/m with AKPP).
4. Unscrew a nut, get a bolt and remove a pedal, if necessary remove plugs.
5. Installation is carried out upside-down. Adjust a pedal and the switch (see subsection 11.3).
6. Tighten all connections according to the demanded moments.
7. Adjust a pedal and the switch.