Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   + 11.13. Back drum-type brakes
   + 11.14. Back disk brakes (1992-98)
   - 11.15. Hand brake
      11.15.1. Adjustment of a cable (1983-91)
      11.15.2. Cable of the hand brake
      11.15.3. Lever of the hand brake
      11.15.4. Blocks of the hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.15.3. Lever of the hand brake

GENERAL INFORMATION

Lever of the hand brake

1. Cable
2. Arm
3. Plug
4. Roller cover
5. Socket
6. Switch
7. Lever
A.Uplotnitel
B.Smazat
V.Kryshka
G.Mesto of hermetic 8661 or 8663 drawing

Removal and installation

PERFORMANCE ORDER
1. Disconnect a cable from an equalizer level.
2. Working in salon, remove floor sections and a box, remove an arm of floor section.
3. Unscrew bolts and remove an arm of the hand brake, get the plug.
4. Uncover the roller of a drive of the hand brake.
5. Disconnect wires and remove the switch of an alarm lamp of the hand brake.
6. Remove the brake lever.
7. Installation is carried out upside-down.