Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
   11.1. Technical characteristics
   11.2. Vacuum amplifier of brakes
   11.3. Adjustment of brakes
   11.4. Switch of a signal of braking
   11.5. Removal and pedal installation
   11.6. Main cylinder of brakes
   11.7. The dosing-out valve
   11.8. Regulator of pressure of back brakes (1992-98)
   11.9. Control valve of the amplifier of brakes
   11.10. Hoses and tubes
   11.11. Air removal from a hydraulic actuator of brakes
   + 11.12. Forward disk brakes
   - 11.13. Back drum-type brakes
      11.13.1. Brake drums
      11.13.2. Replacement of blocks
      11.13.3. Wheel cylinder of back brakes
      11.13.4. Board of a back drum-type brake
   + 11.14. Back disk brakes (1992-98)
   + 11.15. Hand brake
   11.16. Anti-blocking system (ABS)
   11.17. Hydromodule
   11.18. Overload sensor
   11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






11.13.3. Wheel cylinder of back brakes

GENERAL INFORMATION

Details of the back wheel cylinder (on inserts – greasing places before assembly: hermetic (at the left), brake liquid (in the center) and greasing structure ремкомплекта)

1. Drum
2. The union for pumping
3. Union of a tube of a brake
4. Cylinder
5. Cover
6. Piston
7. Piston sealant
8. Cylinder

Check

PERFORMANCE ORDER
Unscrew edge of a cover of the wheel cylinder and examine it from within. At detection of any traces indicating infiltration of liquid under a dustproof cover, the cylinder replace.

Removal and installation

PERFORMANCE ORDER
1. Remove drums and blocks (see subsection 11.13.1, subsection 11.13.2).
2. Substitute the pallet, unscrew the union and muffle a tube and an opening in the cylinder.
3. Disconnect a tube, unscrew fastening bolts.
4. Remove the cylinder.
5. Installation is carried out upside-down.
6. Tighten fastening bolts with the moment of 18 N of m.

Dismantling and assembly

PERFORMANCE ORDER
1. From the removed cylinder carefully remove dustproof covers and get pistons.
2. Check a condition of details, existence on the cylinder of scratches and corrosion traces.
3. Check a gap between the piston and the cylinder. If the gap exceeds 0,15 mm, the cylinder assembled replace.
4. At assembly dress on pistons new a sealant by means of MB990621-01 cone, previously having greased a sealant and a cone with greasing from ремкомплекта or brake liquid.
5. Further assembly is carried out upside-down.
6. Pump over a hydraulic actuator of brakes.