Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
+ 10. Suspension bracket and steering
- 11. Brake system
11.1. Technical characteristics
11.2. Vacuum amplifier of brakes
11.3. Adjustment of brakes
11.4. Switch of a signal of braking
11.5. Removal and pedal installation
11.6. Main cylinder of brakes
11.7. The dosing-out valve
11.8. Regulator of pressure of back brakes (1992-98)
11.9. Control valve of the amplifier of brakes
11.10. Hoses and tubes
11.11. Air removal from a hydraulic actuator of brakes
+ 11.12. Forward disk brakes
+ 11.13. Back drum-type brakes
+ 11.14. Back disk brakes (1992-98)
+ 11.15. Hand brake
11.16. Anti-blocking system (ABS)
11.17. Hydromodule
11.18. Overload sensor
11.19. Sensor of speed
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes
|
| Internal diameter of the main cylinder (mm): |
| – and/m 1983-84. |
22,098
|
| – and/m 1985-87. |
22,225
|
| – and/m 1988-98. |
23,83
|
| Brake disk |
| Thickness of a new disk (mm): |
| – and/m 1983-86. |
20,066
|
| – and/m 1987-91. |
22,00
|
| – and/m 1992-98: |
| • lobbies |
23,90
|
| • the back |
18,03
|
| Residual thickness (mm): |
| – and/m 1983-86. |
18,29
|
| – and/m 1987-91. |
20,39
|
| – and/m 1992-98: |
| • lobbies |
22,35
|
| • the back |
8,38
|
| Palpation, no more than a (mm): |
| – to 1991 incl. |
0,15
|
| – since 1992. |
0,075
|
| Drums of back brakes (polishing of a drum is allowed only for ovality elimination, at reduction of diameter after polishing below norm the drum is subject to replacement) (mm): |
| – internal diameter of a new drum |
254,0 (till 1991 incl.)
|
| – the limiting: |
| • to 1991 incl. |
256,0 mm
|
| • since 1992. |
198,1 mm
|
|
|