Mitsubishi Pajero

1982-1998 of release

Repair and car operation



Mitsubisi Padzhero
+ 1.1. Dashboard and control units
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Greasing system
+ 6. Power supply system
+ 7. Release system
+ 8. Fuel system
+ 9. Running gear
- 10. Suspension bracket and steering
   10.1. Wheels
   + 10.2. Forward suspension bracket
   + 10.3. Back suspension bracket
   - 10.4. Steering
      10.4.1. Removal and wheel installation
      10.4.2. The block of switches on a column
      10.4.3. Ignition lock
      10.4.4. Lock of blocking of a wheel
      10.4.5. Steering column
      10.4.6. Steering drafts
      10.4.7. Pendular lever
      10.4.8. Average steering draft
      10.4.9. Lateral steering drafts
      10.4.10. Steering mechanism
      10.4.11. Pump of the hydraulic booster
      10.4.12. Air removal from the power steering
+ 11. Brake system
+ 12. Body
+ 13. Electric equipment
+ 14. Electroschemes






10.4.5. Steering column

GENERAL INFORMATION

Steering column (1983-98)

1. Bottom facing
2. Air line cover
3. Button of a sound signal
4. Safety cushion module
5. Wheel
6. Bottom casing of a column
7. Top casing of a column
8. Lock of blocking of a shaft of a wheel
9. Cover
10. Cable of blocking of a key
(on and/m with AKPP)
11. The cable handle (on and/m with AKPP)
12. Bolt
13. Steering column

PERFORMANCE ORDER

Prevention

Before the beginning of works take the measures excluding operation of a safety cushion.


1. Disconnect the battery from weight.
2. Remove both casings of a steering column, disconnect wires and take aside.
3. Remove the ignition lock (if it is provided by a design).
4. Remove the bottom air line of a heater.
5. Disconnect wires of a column of a wheel.
6. Remove the lock of ignition and wheel blocking, remove the switch of a reminding signal.
7. Disconnect on a column a spring of a pedal of a brake.
8. Unscrew a bolt of a collar of a shaft of a wheel, bolts of fastening of a cover to the floor panel, bolts of fastening of an arm of a column and remove a column.
9. At installation enter a column shaft into the steering mechanism, check correctness of installation of a column and tighten column bolts with the moment of 22 N of m.
10. Establish all removed details upside-down.
12. Attach wires.
13. Tighten a bolt of a collar of a shaft of a wheel with the moment of 29-34 N of m.
14. At column installation this bolt not to turn on and not to release.
15. Bolts of fastening of a cover wrap on hermetic.